3. Remove the Handrail Screw (53) from one of the | 3 |
Handrails (1). Insert the Handrail into the tube at the top
53
of the left Updght (11), and align the hole in the Handrail with the slotted hole in the Updght. Loosely thread the Handrail Screw into the Handrail, rotate the Handrail until the Screw is touching one end of the slotted hole, and then fully tighten the Screw.
Attach the other Handrail (1) to the right Upright (11) in the same way.
4.Place the Console Base (46) on the tubes on the Updghts (11). Pull out just enough of the two Wires (21) to connect them to the oonnectom in the Console Base. Make a loop with the indicated plastic tie amud the Wires and insert the end through the tie holder on the bottom of the
Console Base. Plug the Wire that has a red connector into the corresponding connector In the Console Base.
The connectors should fit together without being forced; if they do not, rotate the connector on the Wire and then plug it In. Next, plug the other Wire Into the other connector In the Console Base. Important: Make sure that both Wires are fully inserted.
WARNING: Do not disconnect or connect the Wires while the treadmill power cord is plugged in. Pull the plastic tie tight and cut off the end.
Refer to drawing 4b. Thread six Console Screws (99) into |
|
| |
the Uprights (11) and the Console Base (46). After all six |
|
| |
Console Screws have been started, tighten the Screws | 99 | 99 | |
until they are snug; do not overtighten the Screws. | |||
|
|
5.Attach the Storage Latch (14) to the left Updght (11) with two Smafl Screws (13). Be careful not to overtlghten the Latch Screws.
14/__;:>-13
6.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
6
