3.

Attach a Wheel (95) to the Base (99) with an

3

 

 

 

 

 

M10 x 50mm Bolt (26) and an M10 Locknut (36).

 

 

 

 

 

Do not overtighten the Locknut; the Wheel

 

 

 

 

 

 

must turn freely.

 

 

 

 

 

 

 

 

26

 

 

 

 

 

 

36

95

99

 

 

 

 

 

 

 

4. Identify the Right Upright (80) and the Right

4

 

 

 

Wire

 

Upright Spacer (90), which are marked with

 

 

 

 

stickers.

 

 

 

 

Tie

 

Insert the Wire Harness (92) through the Right

 

 

 

 

80

 

Upright Spacer (90) as shown. Then, set the

 

 

 

 

 

 

Right Upright Spacer on the Base (99). Be care-

92

 

 

 

92

 

ful not to pinch the Wire Harness.

 

 

 

 

Have a second person hold the Right Upright

 

 

 

99

90

 

(80) near the Base (99). See the inset drawing.

 

 

 

 

 

Tie the wire tie in the Right Upright securely

 

 

 

 

 

 

around the end of the Wire Harness (92). Then,

 

 

 

 

 

 

pull the other end of the wire tie until the Wire

 

 

 

 

 

 

Harness is routed completely through the Right

 

80

 

 

 

 

Upright.

 

 

 

 

 

 

92

Wire

 

 

 

 

 

Tie

 

 

 

5. Hold a Bolt Spacer (98) inside the lower end of

5

 

 

 

7

 

the Right Upright (80). Insert an M10 x 96mm

 

 

 

 

Bolt (7) with an M10 Star Washer (8) into the

 

80

 

 

 

 

Right Upright and the Bolt Spacer. Repeat this

 

 

 

 

 

step with a second Bolt Spacer (98), M10 x

 

 

 

 

 

 

96mm Bolt (7), and M10 Star Washer (8).

 

 

 

 

892

 

Hold the Right Upright (80) against the Right

 

 

 

 

 

Upright Spacer (90). Be careful not to pinch

 

 

 

 

98

 

the Wire Harness (92). Tighten the M10 x

 

 

 

 

 

96mm Bolts (7) until the heads of the Bolts

 

 

 

 

 

 

touch the Upright; do not fully tighten the

 

 

 

 

90

 

Bolts yet.

 

 

 

 

 

 

8

 

 

 

 

Page 8
Image 8
ProForm 590 lt user manual Do not overtighten the Locknut the Wheel Must turn freely, Ful not to pinch the Wire Harness