8.

Hold a Bolt Spacer (98) inside the lower end of

8

 

 

 

 

 

the Left Upright (79). Insert an M10 x 96mm Bolt

 

 

 

 

 

(7) with an M10 Star Washer (8) into the Left

 

 

7

 

79

 

Upright and the Bolt Spacer. Repeat this step

 

 

 

 

with a second Bolt Spacer (98), M10 x 96mm

 

 

8

 

 

 

Bolt (7), and M10 Star Washer (8).

 

 

 

 

 

Orient the Left Upright (79) and the Left Upright

 

 

 

 

 

 

Spacer (89) as shown. Hold the Left Upright

 

98

 

 

 

 

Spacer and the Left Upright against the Base

 

89

 

 

 

(99). Tighten the M10 x 96mm Bolts (7) until the

 

 

 

 

 

heads of the Bolts touch the Upright; do not fully

 

 

99

 

 

 

tighten the Bolts yet.

 

 

 

 

9.

Press a Base Cap (91) into the Base (99).

9

 

 

 

 

 

With the help of a second person, tip the treadmill

 

91

 

 

 

 

so that the Base (99) is flat on the floor.

 

 

 

 

 

 

 

99

 

 

 

10.

Set the console assembly face down on a soft

10

 

 

 

Console

 

surface to avoid scratching the console assem-

100

 

1

 

bly.

 

 

Wire

 

Identify the Right Handrail (100) which is

 

 

39

 

1

 

marked with a sticker. Hold the Right Handrail

 

Console

 

 

near the console assembly. Attach the console

 

 

 

Large Hole

 

ground wire to the Right Handrail with a #8 x

 

Ground Wire

 

 

1/2" Ground Screw (29).

Console

 

 

1

 

Next, insert the console wire into the large hole

Assembly

 

 

 

in the Right Handrail (100) and pull it out of the

 

 

 

29

 

 

top as shown. Attach the Right Handrail with

 

 

 

 

 

three #8 x 3/4" Screws (1). Make sure that no

 

 

 

 

 

 

wires are pinched. Start all three Screws be-

 

 

 

 

 

 

fore tightening any of them; do not over-

 

 

 

 

 

 

tighten the Screws.

 

 

 

 

 

 

Remove the ties from the M8 Cage Nuts (39). If

 

 

 

 

 

 

necessary, press the Cage Nuts back into place.

10

 

 

 

 

 

 

 

 

 

 

Page 10
Image 10
ProForm 590 lt user manual Tighten the Bolts yet