12.Press a 2” Square Inner Cap (17) into each end of the Leg lever (18).
Press a 48mm Round Inner Cap (12) into the end of the weight tube (G).
Note: The above steps may have been
13. Lubricate the M10 x 72mm Bolt (59).
Attach the Leg Lever (18) to the bracket (H) on the Front Leg (19) with the M10 x 72mm Bolt (59) and an M10 Nylon Locknut (1).
14.Press a 3/4” Round Inner Cap (54) into each end of the three Pad Tubes (46 and 48).
Insert a Short Pad Tube (48) through the upper hole in the Leg Lever (18). Slide two Foam Pads (10) onto the Pad Tube.
Insert the Long Pad Tube (46) through the lower hole in the Leg Lever (18). Slide two Foam Pads (10) onto the Pad Tube.
Insert a Short Pad Tube (48) through one set of holes in the bracket (H) on the Front Leg (19). Slide two Foam Pads (10) onto the Pad Tube.
15.Attach the Cable (45) to the Weight Carriage (37) with the M10 x 19mm Bolt (8) and an M10 Nylon Locknut (1).
12 |
| 17 |
|
| 18 |
| 17 |
|
| 12 | 17 |
|
| G |
13 | H | 19 |
| 1 |
|
| 18 |
|
|
| 59 |
|
| Lubricate |
14 | 10 |
|
| 19 | |
|
| |
| 54 | H |
| 18 | 48 |
|
| |
| 10 | 54 |
|
| |
| 48 |
|
|
| 10 |
|
| 46 |
|
| 54 |
15 |
|
|
|
| 45 |
|
| 8 |
| 1 |
|
|
| 37 |
10
