MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the elliptical exerciser regularly. Replace any worn parts immediately.
To clean the elliptical exerciser, use a damp cloth and a small amount of mild soap. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console displays become dim, the batteries should be replaced; most console problems are the result of low batteries. See assembly step 5 on page 8 for replacement instructions.
HANDGRIP PULSE SENSOR TROUBLESHOOTING
If the handgrip pulse sensor does not function proper- ly, see step 5 on page 16.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch should be adjusted. First, remove all of the screws from both side shields; there are three sizes of screws in the side
Next, locate the |
|
|
| |
Reed Switch (58). |
|
|
| |
Turn the Left | 58 | 41 | 26 | |
Pedal Disc (26) | ||||
| 84 |
| ||
until the Magnet |
|
| ||
(41) is aligned |
|
|
| |
with the Reed |
|
|
| |
Switch. Loosen, |
|
|
| |
but do not |
|
|
| |
remove, the indi- |
|
|
| |
cated M4 x |
|
|
| |
16mm Screw |
|
|
| |
(84). Slide the |
|
|
|
Reed Switch slightly closer to or away from the Magnet, and then retighten the Screw. Rock the Left Pedal Disc forward and backward just enough that the Magnet passes the Reed Switch repeatedly. Repeat
until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the side shields. Note: If you have questions as to which screw should be in which hole, see EXPLODED DRAWING B on page 27 and the PART LIST on page 24.
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance of the pedals is at the high- est setting, the Belt (46) may need to be adjusted.
First, remove all the screws from both side shields; there are three sizes of screws in the side
Next, turn the |
|
Belt Adjustment |
|
Screw (72) until | 46 |
the Belt (46) is |
|
tight. Then, reat- |
|
tach the side |
|
shields. Note: If |
|
you have ques- |
|
tions as to which | 72 |
screw should be | |
in which hole, see |
|
EXPLODED |
|
DRAWING B on page 27 and the PART LIST on page 24.
19
