Generac Portable Products Power Transfer System
TROUBLESHOOTING
Problem | Cause | Solution | |||
| 1. | Generator circuit breaker is | 1. | Reset circuit breaker. | |
|
| open. |
|
| |
Generator is running, but no | 2. | Poor connection or defective | 2. | Check and repair. | |
| cord set. |
|
| ||
AC output is available. |
|
|
| ||
3. | Connected device is bad. | 3. | Select a different appliance or load | ||
| |||||
|
|
|
| that is in good condition. | |
| 4. | Fault in generator. | 4. | Contact authorized service center. | |
Generator runs good but | 1. | Short circuit in a connected | 1. | Disconnect shorted electrical load. | |
bogs down when loads are |
| load. |
|
| |
connected. | 2. | Generator is overloaded. | 2. | See “Load Management” on page 14. | |
| 1. | Load management switches | 1. | Set Load Manager™ switches in GEN | |
|
| in OFF or LINE positions. |
| position. | |
| 2. | Generator circuit breaker is | 2. | Reset circuit breaker. | |
All Load Manager™ switches |
| open. |
|
| |
do not work when on | 3. | Poor connection or defective | 3. | Check and repair. | |
generator power. |
| cord set. |
|
| |
| 4. | Connected device is bad. | 4. | Select a different appliance or load | |
|
|
|
| that is in good condition. | |
| 5. | Fault in generator. | 5. | Contact authorized service center. | |
| 1. | Load management switch in | 1. | Set switch to LINE position. | |
Appliances don’t work after |
| OFF or GEN position. |
|
| |
2. | Load management switch | 2. | Reset circuit breaker. See “Circuit | ||
utility power comes back on. | |||||
| circuit breaker(s) is open. |
| Breakers in Load Manager™ Switch” | ||
|
|
| |||
|
|
|
| section, page 14. | |
Only some loads work on | Load management switch circuit | Reset circuit breaker. See “Circuit | |||
breaker is open. | Breakers in Load Manager™ Switch” | ||||
generator power. | |||||
|
| section, page 14. | |||
|
|
| |||
Wattmeter overloaded. | Connected loads on circuits | Reduce loads on circuits. | |||
exceed 3600 watts. |
|
| |||
|
|
|
15