9.The Console (16) requires four “D” batteries (not included); alkaline batteries are recommended. Press the tab on the battery cover, and lift off the battery cover. Insert four batteries into the battery compart- ment. Make sure that the batteries are oriented as shown by the diagram inside the battery compart-
ment. Reattach the battery cover.
10.While another person holds the Console (16) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (35). Insert the excess wire harness into the Upright (13).
Attach the Console (16) to the Upright (13) with three M10 x 27mm Button Screws (76) and three M10
Black Split Washers (77). Be careful to avoid pinch- ing the wire harnesses.
11. Identify the Left Pedal (24), which is marked with an |
| |||
“L.” Using an adjustable wrench, |
| firmly tighten | the | |
Left Pedal | counterclockwise | into the Left Crank Arm |
| |
(42). Tighten the Right Pedal (not shown) | clockwise |
| ||
into the Right Crank Arm (not shown) in the same way. Important: Tighten both Pedals as firmly as possible. After using the crosstrainer for one
week, retighten the Pedals. For the best perfor- mance, the Pedals must be kept properly tightened.
Adjust the Left Pedal Strap (25) to the desired position and press the end of the Strap onto the tab on the Left Pedal (24). Adjust the Right Pedal Strap (not shown) in the same way.
9 | Tab | |
Battery | ||
| ||
Cover |
| |
Batteries |
| |
| 16 | |
10 |
| |
16 |
| |
Wire Harness |
| |
35 |
| |
76 | 76 | |
77 | 77 | |
| ||
| 13 | |
| 76 | |
11 |
| |
25 |
| |
24 | 42 | |
Tab | ||
|
12. Make sure that all parts of the crosstrainer are properly tightened. | Note: Some hardware may be left |
over after assembly is completed. To protect the floor or carpet from damage, place a mat under the |
|
crosstrainer. |
|
7
