INSTALLING THE RECEIVER FOR THE OPTIONAL CHEST PULSE SENSOR
If you purchase the optional chest pulse sensor (refer to page 18), follow the steps below to install the receiver and the short jumper wire included with the chest pulse sensor.
1.Remove the two short screws and the two long screws from the back of the Console (16). Lift off the front of the Console.
1
16
Lift
Here
Short
Screws
Long
Screws
2.Plug the short jumper wire (A) into the indicated jack on the Console (16). Connect the other end of the short jumper wire to the wire on the receiver (B). Note: Any other wires included with the chest pulse sensor can be discarded.
Next, peel the paper off the adhesive pad on the back of the receiver (B). Orient the receiver as shown, and
press it onto the Console (16) in the indicated location.
Refer to step 1 above. Reattach the front of the |
|
Console (16) with the short and long screws. | Make |
sure that no wires are pinched. |
|
2 | B |
|
|
| |
|
| Cylinder |
| 16 |
|
| Jack | A |
8
