ProForm 831.280440 user manual Assembly

ASSEMBLY

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly can be completed using the included tools; however, a rubber mallet	is also
recommended.

Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 14. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M6 Nylon	M8 Nylon	M10 Nylon	M8 Split	M8 Flat	M10 Split
Locknut (56)–4	Locknut (66)–6	Locknut (64)–4	Washer (81)–4	Washer (73)–4	Washer (54)–6

M4 x 12mm	M6 x 38mm Button	M10 x 17mm Button	M10 x 23mm Button
Screw (77)–2	Bolt (57)–4	Screw (55)–3	Screw (80)–3

M8 x 77mm Button Bolt (58)–2 M10 x 75mm Carriage Bolt (65)–4

1.Attach one of the Stabilizers (19) to the front of the Frame (1) with two M10 x 75mm Carriage Bolts (65) and two M10 Nylon Locknuts (64).

1
65	19
	1
	64

5