ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included hex keys and your own Phillips screwdriver , adjustable
wrench , and rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the parentheses is the quantity needed for assembly. Note: Some small parts may have been pre- assembled. If a part is not in the parts bag, check to see if it has been preassembled. If a part is missing, call
M8 Split | M10 Split | M8 | Handlebar | M10 |
Washer | Washer | Washer | Washer | Washer |
Wave | Large Wave | M8 Nylon | M10 Nylon | M4 x 22mm |
Screw | ||||
Washer | Washer | Locknut | Locknut |
|
M8 x 25mm Patch |
| M8 x 52mm Button |
| M10 x 27mm |
Screw |
| Screw |
| Patch Screw |
M10 x 74mm Button Bolt |
| M10 x 75mm Carriage Bolt | ||
M8 x 45mm Button Bolt |
| M6 Bolt Set | ||
|
| 5 |
|
|