3.Identify the Right Handrail (47), which has a large hole in the left side. Feed the Wire Harness (21) through the bot- tom of the bracket and out of the large hole in the left
side. (Note: It may be helpful to use needlenose pliers to pull the Wire Harness out of the large hole.) Press a Handrail Cap (41) onto the lower end of the Right Handrail as shown.
Insert the rectangular bracket on the Right Handrail (47)
into the top of the right Upright (11) so the Handrail Cap
(41)is resting against the right Upright. Attach the Right Handrail and the Handrail Cap with three 1” Bolts (8) and
two Washers (39) as shown. | Do not tighten the Bolts |
yet. |
|
Attach the Left Handrail (not shown) as described above. Note: There is not a wire harness on the left side.
4.Attach the end of the ground wire to the small hole in the side of the Right Handrail (47) with a Silver Ground Screw (104).
5.Place the Console Base (46) on the Right Handrail (47) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (13) (only two Screws are shown). Do not tighten the Screws yet.
Insert the Wire Harness (21) through the two indicated plastic ties on the Console Base (46). Next, insert the Wire Harness up through the opening beside the Console Cover (96). Make sure that the Console Cover is securely attached to the Console Base.
Refer to the inset drawing. Look at the top of the Console
Base (46). Insert the Wire Harness (21) through the plas- tic tie on top of the Console Base.
3 |
|
|
| 21 |
|
| Large |
|
| Hole |
|
| Bracket | 8 |
|
| |
| 47 | 39 |
|
| |
| 8 | 11 |
| 39 |
|
|
| 41 |
| 8 |
|
4 |
|
|
| Ground |
|
| Wire |
|
| 104 |
|
| 47 |
|
5 | 46 |
|
|
| |
| 21 |
|
| 96 |
|
| Ties |
|
13 | 47 |
|
|
| |
| 21 | Tie |
|
| |
|
| 46 |
6
