ProForm 831.293230 Change the incline of the treadmill as desired, Fat Calories/Calories

To stop the walking belt, press the Stop button.

The elapsed time will begin to flash in the

Time/Distance display.

Note: During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and align it if necessary (see page 14).

3 Change the incline of the treadmill as desired.

To change the incline of the treadmill, press either of the Incline buttons until the desired incline level is reached.

4 Follow your progress with the three displays.

Time/Distance
	Mode Indicator
display —This display
shows the elapsed time
and the distance that
you have walked or run.
The display will change
from one number to the

other every few seconds, as shown by the mode

indicators. When the Stop button is pressed, the
elapsed time will flash.
Fat Calories/Calories/
Pulse display	—This
display shows the ap-
proximate numbers of
fat calories	and calories

you have burned (see

FAT BURNING on page 15). The display will change from one number to the other every few seconds, as shown by the mode indicators. The display will also show your heart rate when you use the pulse sensor (see step 5).

Speed display —This

display shows the speed of the walking belt

Note: The console can

display speed and dis- tance in either miles or kilometers. To change the unit of measure-

ment, hold down the

Stop button, insert the key into the console, and

continue to hold the Stop button for a moment. An

“E” for English miles or an “M” for metric kilometers will appear in the Fat Calories/Calories/Pulse dis- play. Press the Speed ▲ button to change the unit of measurement. When the desired unit of mea-

surement is selected, remove the key and then reinsert it.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

5 Measure your heart rate if desired.

To measure your heart rate, stand on the foot rails and place your thumb

on the pulse sensor.

Do not press too hard, or the circu- lation in your

thumb will be restricted and your pulse will not

be detected. After a few seconds, the heart- shaped indicator in the Fat Calories/Calories/ Pulse display will begin to flash, one or two dashes (– –) will appear, and then your heart rate will be shown. Hold your thumb on the pulse sensor for about 15 seconds for the most accurate reading.

If the displayed heart rate appears to be too high

or too low, or if your heart rate is not displayed, lift your thumb off the pulse sensor for a few seconds. Then, place your thumb on the pulse sensor as de-

scribed above. Remem	ber to stand still while mea-
suring your heart rate.

6 Whenkey. you are finished exercising, remove the

Step onto the foot rails, press the Stop button, and remove the key from the console. Keep the key in a secure place.

WARNING: Removing the key does not cut off power to the incline sys-

tem. To prevent movement of the treadmill and possible injury, unplug the power cord when the treadmill is not in use.

10