ProForm 831.295550 user manual Hole in the Housing is on the indicated side. Next, re

2. Attach the Latch Housing (29) to the left Upright (69)	2
with two 3/4” Screws (2). Note: Make sure the large		73
hole in the Housing is on the indicated side. Next, re-
move the knob from the pin. Make sure that the collar	Knob		29
and the spring are on the pin. (Note: If there are two col-
lars, place one on each side of the spring.) Insert the pin				Large Hole	42
into the Latch Housing (29), and tighten the knob back
onto the pin.	2				73
		Pin
Cut any ties holding the Upright Wire (42) to the the	Spring
Upright (69). Insert the Upright Wire through an Upright
Cap (73). Press the Upright Cap onto the right Upright	Collar			69
(69). Make sure that the ridges on the sides of the					69
Upright Cap slide into the notches in the Upright.
3. Identify the Right Handrail (72), which has a large hole in	3
the left side. Feed the Upright Wire (42) into the hole in
the bottom of the Right Handrail and out of the large hole	37			71
in the side. (Note: It may be helpful to use needlenose
pliers to pull the Upright Wire out of the hole.) Next, slide					72
a Handrail Endcap (103) onto the lower end of the Right
Handrail, and rotate the Handrail Endcap so that the			69	Hole
small pin is at the top.
				42
Attach the upper end of the Right Handrail (72) to the				37
					Hole
right Upright (69) with a Handrail Bolt (37). Do not
tighten the Handrail Bolt yet. Attach the lower end of
the Right Handrail with a Lower Handrail Bolt (98) and a				98
Star Washer (101). Tighten both Bolts.					69
Attach the Left Handrail (71) as described above. Note:			101		Pin
There is not an upright wire on the left side.
				103
					98
					101

7