ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench | , and your own adjustable wrench | , phillips | |
screwdriver | , and scissors | . |
|
1.Refer to the drawing on page 4 and identify the left side of the treadmill. With the help of a second person, carefully lay the treadmill on its left side.
Firmly slide an Extension Leg (99) into the Base (70) as shown. Make sure that the Extension Leg is turned so the Base Pad (89) is on the indicated side. Using the in- cluded Allen Wrench (92), attach the Extension Leg with an Extension Screw (93). While the treadmill is on its side, attach the other Extension Leg (not shown) in the same manner.
With the help of a second person, carefully raise the treadmill to the vertical position so both Extension Legs (99) are resting flat on the floor.
2.Remove the four Latch Screws (108) from the left Upright (70).
Without removing the tape from the Latch Bracket (60) and Latch Spacer (66), hold the Latch Spacer against the left Upright (70) as shown. Attach the Latch Bracket and the Latch Spacer with the four Screws. Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Storage Latch (69) will not slide smoothly. After the Latch Bracket is attached, remove any visible tape.
Note: The inset drawing shows how the Latch Bracket (60), Latch Springs (68), Storage Latch (69), and Latch Spacer (66) fit together.
3.Remove the indicated Screw (4) from the treadmill Frame (1). Attach the plastic Catch (5) to the Frame with the Screw. Note: It may be necessary to slide the Storage Latch (69) to the left while attaching the Catch.
1 |
|
|
92 | 93 |
|
70 |
|
|
|
| 89 |
| 99 |
|
2 |
|
|
70 | 60, 66 |
|
| 69 |
|
108 | 66 |
|
|
| 68 |
| 60 | 69 |
3 |
|
|
1 |
|
|
69 | 5 |
|
4 |
|
|
5
