Remove the three 3/4" Screws (12) and carefully pivot the Hood (61) off.
12 |
61 |
Locate the Reed Switch (71) and the Magnet (50) |
|
|
on the left side of the Pulley (51). Turn the Pulley |
|
|
until the Magnet is aligned with the Reed Switch. | 1/8 in. |
|
Make sure that the gap between the Magnet and |
| |
the Reed Switch is about 1/8 in. (3 mm). If neces- | 71 | 50 |
sary, loosen the 3/4" Reed Switch Screw (15), | ||
move the Reed Switch slightly, and then retighten | Top | 51 |
the Screw. Reattach the Hood (not shown). If nec- |
| |
essary, tip down the Uprights (not shown), reattach | View |
|
the Hood Screws (not shown) and raise the |
|
|
Uprights. Run the treadmill for a few minutes to |
|
|
check for a correct speed reading. |
|
|
PROBLEM: The console displays remain lit when you remove the key from the console
SOLUTION: a. The console features a display demo mode, designed to be used if the treadmill is displayed in a store. If the displays remain lit when you remove the key, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds. If the displays are still lit, see THE INFORMATION MODE on page 19 to turn off the demo mode.
PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- | b |
|
mance may decrease and the walking belt may be- | ||
come damaged. Remove the key and UNPLUG |
| |
THE POWER CORD. Using the hex key, turn both |
|
|
rear roller bolts counterclockwise, 1/4 of a turn. |
|
|
When the walking belt is properly tightened, you |
|
|
should be able to lift each edge of the walking belt |
|
|
2 to 3 in. (5 to 7 cm) off the walking platform. Be |
|
|
careful to keep the walking belt centered. Then, |
|
|
plug in the power cord, insert the key, and run the | Rear Roller Bolts | |
treadmill for a few minutes. Repeat until the walking | ||
belt is properly tightened. |
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual.
23
