ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key | and your own Phillips screwdriver | . | , | |
adjustable wrench | , wire cutters | , and rubber mallet |
| |
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly. Extra hardware may be included.
Bolt Spacer | Base Foot Spacer | 3/8" Star Washer | 3/8" Nut | ||
|
|
| |||
|
|
|
|
| |
3/8" x 1/2" Bolt | 3/8" x 2" Bolt |
| 3/8" x 3" Bolt |
| |
|
|
|
|
| |
#8 x 1" Tek Screw |
|
| 3/8" x 4 1/2" Bolt |
| |
1.Make sure that the power cord is unplugged. With the help of a second person, carefully tip the treadmill onto its left side. Partially fold the Frame (56) so that the treadmill is more stable; do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A) and the shipping bracket (B).
Cut the tie securing the Upright Wire (38) to the Base (83). Locate the tie in the indicated hole in the Base, and use the tie to pull the Upright Wire out of the hole.
1 | B | A |
|
| 38 | ||
|
| ||
56 | 83 Hole |
|
|
|
|
|
6
