8.Press the Upright Wire (42) into the slot in the underside of the Console Base (47) in the indicated area. Cover the Upright Wire with the Right Grip Plate (36). Be careful not to pinch the Upright Wire. Tighten three 3/4” Screws (2) into the Right Grip Plate and the Console Base.
Attach the Left Grip Plate (32) over the ground wire and the other wires with three 3/4” Screws (2). Be careful not to pinch any of the Wires.
9.With the help of a second person, lower the Uprights (69) to the floor.
Align the lower ends of the Handrails (71, 72) with the in- dicated holes in the Extension Legs (63). Attach each Handrail with a 3” Bolt (37) as shown. Note: The Bolts must be at an angle that matches the angle of the Handrails, as shown in the inset drawing. Firmly tighten the Bolts.
With the help of a second person, carefully tip the Uprights (69) back to the vertical position.
10.Attach the Storage Latch (29), with the Latch Spacer (121), to the left Upright (69) with two 3/4” Screws (2) as shown. Do not overtighten the Screws.
8 |
|
| 47 |
|
| Slot |
|
| Ground |
|
|
|
| |
|
|
|
| Wire |
|
|
| 42 |
|
|
| 36 | 32 |
|
|
|
|
| |
| 2 |
| 2 |
|
|
|
|
| |
9 |
|
|
|
|
|
|
|
| 37 |
|
|
| 71 |
|
|
|
| 63 |
|
69 | 37 |
|
| 37 |
72 |
|
|
|
|
63 |
|
| 72 | 63 |
|
|
| ||
10 |
|
|
|
|
| 69 |
|
|
|
| 121 |
|
|
|
| 29 |
| 2 |
|
|
|
|
|
11.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet, place a mat under the treadmill.
9
