ASSEMBLY
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish assembly.
•After shipping, there may be an oily substance on the exterior of the treadmill. This is normal. If there is an oily substance on the treadmill, wipe it off with a soft cloth and a mild,
•Left parts are marked “L” or “Left” and right parts are marked “R” or “Right.”
•To identify small parts, see page 6.
•Assembly requires the following tools:
the included hex keys one adjustable wrench one Phillips screwdriver
scissors
needlenose pliers
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged. | 1 |
|
Place a piece of cardboard below the rear of the |
| |
|
| |
Frame (56) to protect the floor or carpet. |
|
|
Attach the Left Wheel Cap (96) to the Base (94) |
|
|
with two #8 x 3/4" Screws (2). |
| 56 |
|
| |
Attach the Right Wheel Cap (not shown) to |
|
|
the right side of the Base (94) in the same |
|
|
way. | 94 |
|
|
| |
| 2 |
|
|
| 96 |
|
| Cardboard |
2. Pull the Upright Wire (81) and the base ground | 2 |
|
wire (A) through the indicated hole in the Base |
| |
|
| |
(94). |
|
|
Attach the base ground wire (A) to the Base (94) |
| 77 |
with a #8 x 1/2" Ground Screw (10). | Hole | |
|
| |
Press the Grommet (77) into the square hole in | 81 |
|
the Base (94). |
|
|
| 10 | A |
| 94 | |
| 7 |
|
