6.Insert the Backrest Bracket (7) through the slot in the Bench Frame (1) and under the Adjustment Lever (11). Make sure that the M10 x 62mm
Flat Head Screw (27) is under a notch in the Backrest Bracket.
Lubricate an M10 x 155mm Bolt (109) with grease. Attach the Backrest Tubes (8) to the Bench Frame (1) with the Bolt, two M10 Washers (99), and an M10 Nylon Locknut (97). Do not overtighten the Locknut; the Backrest Tubes must be able to pivot easily.
7.Attach the Backrest (14) to the Backrest Tubes
(8) with four M6 x 38mm Screws (102) and four M6 Washers (101).
Tighten the six M10 Nylon Locknuts (97) used in steps 1 and 5.
8.Attach the Seat (15) to the Bench Frame (1) with an M6 x 63mm Screw (103), an M6 Washer (101), and two M6 x 16mm Screws (104).
6 |
| |
| 8 | |
97 |
| |
99 | 27 | |
| ||
1 |
| |
| 99 | |
11 | 109 | |
7 | Lubricate | |
| ||
7 |
| |
14 |
| |
| 8 | |
| 101 | |
101 | 102 | |
101 | ||
| ||
102 |
| |
8 |
| |
15 |
| |
1 |
| |
| 101 | |
104 | 103 |
7
