3. Attach the Handlebar (5) to the Upright (4) with | 3 |
|
|
|
an M10 x 157mm Button Bolt (30), two M10 |
|
|
| |
Curved Washers (39), and an M10 Locknut |
|
|
|
|
(38). |
| 5 |
|
|
Tip: It may be helpful to use a hex key to | 30 |
|
| |
turn the M10 x 157mm Button Bolt (30) while |
|
|
| |
you are inserting it through the Handlebar |
| 39 |
|
|
(5) and the Upright (4). |
|
|
| |
Secure the Handlebar (5) with the Handlebar | 4 |
| 39 | 38 |
Knob (37). |
| |||
|
|
| 37 |
|
4. Using a small plastic bag to keep your hand | 4 |
|
|
|
clean, apply a small amount of the included |
|
|
| |
grease to both sides of a Pivot Washer (43) and |
|
|
|
|
to the axle on the Pivot Frame (3). |
|
|
|
|
Slide the Pivot Washer (43) onto the axle on the |
|
|
|
|
Pivot Frame (3). Then, insert the Pivot Frame |
|
|
|
|
into the Frame (1). |
| 3 |
|
|
Attach the Pivot Frame (3) with an M8 x 15mm |
|
|
| |
Button Screw (29) and a Large Washer (41). Do |
|
|
|
|
not overtighten the Button Screw; the Pivot |
|
| Grease |
|
Frame must pivot freely. |
|
|
| |
|
| 43 |
|
|
|
| 1 |
|
|
|
| 41 | 29 |
|
| 7 |
|
|
|
