14.Insert an M10 x 20mm Bolt (89) into the Weight Carriage (42) from the side shown.
Slide the Weight Carriage Stop (58) onto the Rear Upright (41). Then, slide the Weight Carriage (42) onto the Rear Upright.
15.Attach a Guide Rod (46) to the Left Rack Base (37) with an M8 x 53mm Bolt (9), two M8 Washers (83), an 11mm x 8mm Spacer (82), and an M8 Nylon Locknut (78). Do not tighten the
Nylon Locknut yet.
Attach a Guide Rod (46) to the Right Rack Base (38) in the same manner.
16.Attach a Barbell Stop Hook (48) to a Barbell Stop (47) with an M10 x 25mm Bolt (88) and an M10 Nylon Locknut (77). Do not tighten the Nylon
Locknut yet; the Stop Hook should pivot easily.
Slide a Bumper (4) and the Barbell Stop (47) onto the right Guide Rod (46).
Identify the Right Barbell Guide (53) by the loca- tion of the screw hole. Slide the Right Barbell Guide onto the right Guide Rod (46).
Repeat this step with the left Guide Rod (not shown).
14 |
|
|
| 89 |
|
42 |
|
|
58 |
|
|
41 |
|
|
15 |
|
|
38 |
|
|
46 |
|
|
|
| 37 |
|
| 46 |
| 9 |
|
| 83 | 82 |
|
| 83 |
|
| 78 |
16 |
|
|
Screw | 53 |
|
|
| |
Hole |
|
|
77 |
|
|
| 47 |
|
48 | 88 |
|
|
| |
4 |
|
|
| 46 |
|
10
