5.Press three 50mm Square Inner Caps (17) into the Leg Lever (18).
Attach a Weight Tube (39) to the Leg Lever (18) with an M8 x 60mm Bolt (43), two M8 Washers (23), the 13mm Spacer (50), and an M8 Nylon Locknut (13).
6.Press the Angle Cap (49) onto the indicated end of the Weight Tube (39). Press a 25.4mm Round Inner Cap (12) into the other end of the Weight Tube.
Lubricate an M10 x 75mm Bolt (26). Attach the Leg Lever (18) to the bracket on the Front Leg (19) with the Bolt, two M10 Washers (6), and an M10 Nylon Locknut (11). Do not overtighten the Nylon
Locknut. You must be able to freely pivot the Leg Lever.
7.Press a 38mm Round Inner Cap (45) into each end of the Adjustment Tube (29).
To mount the Adjustment Tube (29), insert the end without the locking clip through the left Upright (1) from the inside. Then, slide the end with the locking clip into the right Upright (1). Rotate the locking clip into place around the Upright. When moving the
Adjustment Tube (29), always make sure the locking clip is in place around the right Upright
(1).
Tighten all of the Nylon Locknuts used in steps 1 to 7.
8.Press 25.4 Square Inner Caps (28) into the ends of both Backrest Tubes (27).
Attach the Backrest Tubes (27) to the Backrest (15) with four M6 x 40mm Bolts (4) and four M6 Washers (30). Do not tighten the four Bolts yet.
5 |
| 17 |
|
| |
| 18 |
|
17 |
| 23 |
|
| |
| 13 |
|
| 50 |
|
39 |
|
|
| 17 | 43 |
6 |
|
|
11 | 6 |
|
18 |
|
|
|
| 6 |
| 49 | 26 |
|
| 19 |
39 |
|
|
12 |
|
|
7 |
|
|
1 | 45 |
|
|
| |
|
| 1 |
|
| 29 |
Locking |
|
|
Clip |
|
|
|
| 45 |
8 |
|
|
15 |
|
|
|
| 28 |
28 |
| 30 |
|
| 30 |
27 |
| 4 |
4 |
| |
|
|
8
