ProForm PFCCEL45011 user manual Assembly, Wrench A rubber mallet

ASSEMBLY

Assembly requires two persons.	Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.			In	addition to the
included allen wrenches, assembly requires a phillips screwdriver			, an	adjustable
wrench	, and a rubber mallet	.
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 22. The second number refers to the quantity used in assembly.			Note: Some small parts may have been
pre-assembled for shipping. If a part is not in the parts bag, check to see if it has been pre-assembled.

M8 Nylon	M10 Nylon	M10 Split	Handlebar	M10
Locknut (38)–4	Locknut (33)–4	Washer (59)–6	Washer (55)–2	Washer (78)–2
M4 x 16mm
Screw (52)–2	M6 x 25mm	M8 x 19mm Button	M10 x 27mm	Spring Bracket
	Screw (7)–1	Screw (56)–2	Pedal Bolt (80)–2
				Washer (35)–2
M8 x 45mm Button Screw (50)–4			M10 Bolt Set (74)–2
M10 x 27mm	M10 x 27mm		M10 x 75mm Carriage Bolt (34)–4
Patch Screw (40)–2	Screw (67)–6

1.Identify the Front Stabilizer (10), which has Wheels (22) attached to it. While another person lifts the front of the Frame (1), attach the Front Stabilizer to the Frame

with two M10 x 75mm Carriage Bolts (34) and two

M10 Nylon Locknuts (33). Make sure that the Front

Stabilizer is turned so the Wheels are not touching the floor.

1
22
34
22
	1
34
10	33

5