ProForm PFEL03010 user manual

3.Insert the pulse wires beneath the indicated bracket on the Upright (3) and up out of the hole in the top of the Upright. Attach the T-Handle (10) to the Upright with two M6 x 16mm Screws (54) and two M6 Black Nylon Locknuts (55).

4.While another person holds the Console (6) near the Upright (3), attach the ground wire to the Upright with an M4 x 16mm Screw (34). Connect the Extension Wire (61) to the corresponding console wire. Connect the pulse wires to the corresponding console wires.

Pull any slack Resistance Cable (26) up out of the Upright (3) and push it into the Console (6). Feed the slack Extension Wire (61) down into the Upright. Attach the Console to the Upright with four M4 x 16mm Screws (34). Be careful to avoid pinching the wires or pinching or kinking the Resistance Cable.

Press the Resistance Knob (50) onto the upper end of the Resistance Cable (26).

5.Find the Left Pedal (31), which has a ridge on the right side. Attach the Left Pedal to one of the Pedal Arms (12) with three M4 x 19mm Round Head Screws (16) as shown.

Repeat this step to attach the Right Pedal to the other Pedal Arm (not shown).

6.Locate the Left Handlebar (8) (there is an “L” sticker on the Left Handlebar for identification). Apply a thin film of the included grease to the axle at the lower end of the Left Handlebar.

Slide a Handlebar Spacer (39) and the Pedal Arm

(12)with the Left Pedal (31) onto the Left Handlebar

(8)as shown. Make sure that there are two Pedal Arm Bushings (11) in the Pedal Arm. (Note: These parts fit tightly; it may be helpful to use a rubber mal- let). Next, refer to the PART IDENTIFICATION CHART on page 5 and identify the 3/4” Axle Caps

(43).Tap a 3/4” Axle Cap onto the Left Handlebar.

Repeat this step to attach the other Pedal Arm (12) to the Right Handlebar (62).

7

3
		Pulse
		Wires
Hole		54
Bracket
3		10
		55
4	6	50
Console	26
Wires
61		26
		Pulse Wires
	34	Ground
		Wire
34
		3
5		Ridge
		31
		12
16
6
		62
	8	12
39
11
43
		Grease
12
	31