7. Attach the Left Pedal Arm (21) to the left Upper | 7 |
|
|
Body Arm (6) with an M8 x 25mm Patch Screw |
|
| |
|
|
| |
(70), an M8 Washer (64), and a Pedal Leg Cover |
| 6 |
|
(23). |
|
| |
|
|
| |
Apply grease to a Large Wave Washer (20) and |
| 73 |
|
slide it onto the Left Crank Arm (42). Then, attach |
|
|
|
the Left Pedal Arm (21) to the Left Crank Arm with |
| 21 |
|
an M8 x 25mm Patch Screw (70) and an M8 Large |
|
| |
64 |
|
| |
Washer (81). |
|
| |
|
|
| |
Repeat this step for the other side of the elliptical | 70 | 23 | 20 |
exerciser. |
| ||
|
| 81 | |
See step 3. Tighten the four M8 x 19mm Patch |
| 70 | |
|
|
| |
Screws (73). |
|
|
|
8. The Console (10) requires four “D” batteries (not | 8 |
|
|
included); alkaline batteries are recommended. |
|
| |
|
|
| |
Remove the battery cover from the Console. Insert |
|
|
|
four batteries into the Console; make sure that the |
|
|
|
batteries are oriented as shown by the markings |
|
|
|
inside of the battery compartment. Then, reattach |
|
|
|
the battery cover. |
|
|
|
10 | Batteries |
|
Battery
Cover
9.While another person holds the Console (10) near the Upright (2), connect the Upper Wire Harness (18) to the wire harness on the Console.
Attach the Console (10) to the Upright (2) with four M4 x 16mm Screws (60). Be careful not to pinch the wire harnesses.
Attach the Water Bottle Holder (17) to the Upright (2) with two M4 x 22mm Screws (66).
9
10
18
60
60
17
2
66
8
