1.To make assembly easier,read the information on page 5 before you begin assembling the ellipticalexerciser.
Attach a Wheel (8) to one side of the Frame (1) with an M10 x 35mm Shoulder Screw (57).
Attach the other Wheel (not shown) in the same way.
2.Apply a generous amount of the included grease to the Pivot Axle (41). Then, insert the Pivot Axle through the Frame (1).
Apply a small amount of grease to a 16mm Wave Washer (66). Slide the Wave Washer onto the right side of the Pivot Axle (41).
Identify the Right Upper Body Arm (37), which is marked with an “R” sticker. Make sure that the ends of the Right Extension Wire (83) are oriented as shown.
Slide the Right Upper Body Arm (37) onto the Pivot Axle (41). Then, insert the end of the Right Extension Wire (83) upward through the Frame (1).
Tip: Avoid pinching the Right Extension Wire (83) during this step. Attach the Right Upper Body Arm (37) with an M8 x 25mm Patch Screw (77), a Pivot Axle Cover (44), and an M8 x 25mm Washer (54).
Attach the Left Upper Body Arm (23) in the same way.
Tip: Use an elastic band or a piece of tape to prevent the ends of the Wire Harness (73) and the Right and Left Extension Wires (83, not shown) from falling into the Frame (1).
1 |
|
1 | 8 |
| |
| 57 |
2 |
| Avoid pinching the | |||
83 |
| ||||
| wires during this step | ||||
73 | 1 |
|
|
|
|
|
|
|
|
| |
| 41 | 83 | 83 |
|
|
23 |
|
|
| ||
Grease 66 | 54 |
| |||
|
| 44 | |||
|
|
| 37 |
| 77 |
6
