6.While another person holds the Upright (13) in the position shown, connect the console wire to the Reed Switch Wire (43). Next, connect the console cable to the Lower Cable (36) in the following way:
•Refer to inset drawing A. Pull up on the metal brack- et on the Lower Cable (36), and insert the tip of the
console cable (CC) into the wire clip inside of the metal bracket.
•Refer to inset drawing B. Firmly pull the console cable (CC) and slide it into the metal bracket on the Lower Cable (36) as shown.
•Refer to inset drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together.
Insert the excess wire and cable down into the Frame
(1). Insert the Upright (13) into the Frame. Make sure that the wires and cables are not pinched. Attach the Upright to the Frame with three M8 x 25mm Button Screws (47) and three M8 Black Split Washers (42).
7.Attach the Seat (12) to the Seat Post (5) with four M8 Nylon Locknuts (10) and four M8 Black Split Washers (42). Note: The Nylon Locknuts and Split Washers may be preattached to the Seat.
Turn the Seat Knob (28) counterclockwise two or three turns to loosen it (if the Seat Knob is not loosened enough, it may scratch the Seat Post [5]). Next, pull the Seat Knob, slide the Seat Post into the Frame (1), and then release the Seat Knob. Move the Seat Post up and down slightly until the pin on the Seat Knob snaps into one of the holes in the Seat Post. Then, turn the Seat Knob clockwise until it is tight.
47nsole
C_n_r1
ABC
BMet_let _(I
Metal j
CC i Bracket
......
12/
1
6
