ProForm PFHK99902 user manual Assembly, Wrench and your own phillips screwdriver

Assembly

Assembly requires two people. Set the incline trainer in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen

wrench and your own phillips screwdriver .

Note: The underside of the incline trainer walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a nor- mal condition and does not affect trainer performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Refer to the drawings below to identify the parts used in assembly.

Internal Star	1” Upright Bolt (33)–4	Handrail Bolt (25)–4
		Handrail Star
Washer (32)–4		Washer (26)–4
	Long Upright Bolt (54)–4
		Small Screw (6)–4

1.Set the Console (99) and the Handrail (27) on the floor.

Locate the Handrail Wire Harness (30) in the Handrail

(27). While a second person holds the Console (99), con- nect the 8-pin wire of the Handrail Wire Harness to the HD2 connector on the back of the Console. Next, connect the 4-pin wire to the IFIT2 connector, and the 3-pin wire to the HD1 connector shown.

2.Attach the Console (99) to the Handrail (27) with the four Small Screws (6). Make sure that the Handrail Wire

Harness (not shown) is not pinched between the Console and the Handrail.

1
		HD1
		IFIT2
		HD2
	99	30
		27
2		6
		99

6

27

6

6