ProForm PFHK99902 user manual Problem The power turns off during use, Loosen, Turns Top View

PROBLEM: The power turns off during use

SOLUTION: a. Check the circuit breaker located on the trainer near the power cord (see c. on page 20). If the circuit breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure that the power cord is plugged in.

c.Remove the key from the console. Re-insert the key fully into the console.

d.Make sure that the on/off switch is in the “on” position.

e.If the incline trainer still will not run, please call our Customer Service Department, toll-free.

PROBLEM: The key is inserted and the displays on the console are lit, but the walking belt will not start

SOLUTION: a. Unplug the power cord, wait for five minutes, and then plug the power cord back in.

PROBLEM: The displays of the console do not function properly

SOLUTION: a. Remove the key from the console and UNPLUG THE POWER CORD. Remove the two indicated Screws

(43)from the Belly Pan (16). Loosen the other indi- cated Screw three turns. Carefully lift off the Front Roller Cover.

b.Locate the Reed Switch (87) and the Magnet (13) on the side of the Pulley (11). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8”. If necessary, loosen the Screw

(43)and move the Reed Switch slightly. Retighten the Screw. Re-attach the front roller cover, and run the trainer for a few minutes to check for a correct speed reading.

a	43
Loosen
	three
	turns
	16
	43
b
		1/8”
		87
	13	43
		Top
	11	View

PROBLEM: The grade of the incline trainer does not change correctly or does not change when iFIT.com CD’s and videocassettes are played

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the grade is changing, re- move the key. After a few seconds, re-insert the key. The incline trainer will automatically rise to the highest grade and then return to the lowest grade. This will recalibrate the trainer.

b. If an “E6” appears in the Distance/Time display, remove the key and unplug the power cord. Wait for sixty seconds, plug in the power cord, and re-insert the key.

21