ProForm PFRX35390 user manual Screws

5.Connect the Reed Switch Wire (13) and the two Extension Wires (41) to the corresponding wires on the Console (8).

If your Console (8) has a ground wire, attach it to the Upright (2) with an M4 x 16mm Screw (34).

Next, attach the Console (8) to the Upright (2) with four #8 x 5/8Ó Screws (22).

Press the Resistance Knob (9) onto the Resistance Control (10). Be sure that the mark on the Knob is correctly aligned.

6.Finish attaching the Handlebar (4) and the Light Frame (82) to the Upright (2) with two more M6 x 25mm Hex Head Screws (14) and two more M6 Split Washers (67). Tighten all four Hex Head

Screws.

Remove the backing from the Cord Clips (95) and and press them onto the exercise cycle in the indi- cated locations. Insert the Power Cord (73) into the Cord Clips. Make sure that the Power Cord can- not get caught on the pedals while you are exer- cising.

7.Attach the Seat Bracket (69) to the Seat Frame (3) with four M10 x 105mm Button Head Bolts (70), four M10 Flat Washers (71), and four M10 Nylon Locknuts (72).

8.Attach the Seat (16) to the Seat Bracket (69) with four M6 x 16mm Hex Head Screws (24).

5
8	9
Console
Wires
13 41	Ground
	Wire
	34
	10
22	2
	22
6
	14
	67
82
14	4
67
73	2
95
7	70
	69
	3
71
72	71
8	16
	69
24

7