ASSEMBLY
•To hire an authorized service technician to assemble the treadmill, call
•Assembly requires two persons.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until you finish all assembly steps.
•After shipping, there may be an oily substance on the exterior of the incline trainer. This is nor- mal. If there is an oily substance on the incline trainer, wipe it off with a soft cloth and a mild,
•To identify small parts, see page 6.
•Assembly requires the following tools:
the included hex key one adjustable wrench one Phillips screwdriver one pair of scissors
To avoid damaging parts, do not use power tools.
1. Make sure that the power cord is unplugged. | 1 |
|
Place a piece of cardboard below the rear of the |
| |
|
| |
Frame (56) to protect the floor or carpet. |
|
|
Attach the Left Wheel Cap (96) to the Base (94) |
|
|
with two #8 x 3/4" Screws (2). |
| 56 |
|
| |
Attach the Right Wheel Cap (not shown) to |
|
|
the right side of the Base (94) in the same |
|
|
way. | 94 |
|
|
| |
| 2 |
|
|
| 96 |
|
| Cardboard |
2. Pull the Upright Wire (81) and the Base Ground | 2 |
|
Wire (110) through the indicated hole in the Base |
| |
|
| |
(94). |
|
|
Attach the Base Ground Wire (110) to the Base |
|
|
(94) with a #8 x 1/2" Ground Screw (10). | Hole |
|
|
| |
| 81 |
|
|
| 110 |
| 10 | 94 |
| 7 |
|
