Sun Microsystems EC000066 manual Positioning the outer/middle rail assembly in the rack

INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK

1.Position the inner rail (A below) against the chassis with the slide-rail lock (B) at the front.

E

D

C

C

C

A

B

2.Align the three pairs of keyed openings on the inner rail with the three pairs of locating pins on the side of the chassis (C above).

3.While pressing the rear of the rail against the side of the chassis, push the rail toward the rear of the chassis (D above) until the rail clip (E) locks into place with an audible click.

4.Make sure that all six locating pins are locked into the keyed openings.

Next task: Once both inner rails have been attached, go to “Positioning the outer/middle rail assembly in the rack” on page 5.

▼Positioning the outer/middle rail assembly in the rack

The VTL Value appliance is four rack-units (4U) high and quite heavy, due to the number of internal storage disks installed. You must therefore position the appliance in the rack carefully. The chosen location must allow enough space for a 4U appliance while presenting the smallest possible tipping hazard. Proceed as follows.

316196101 • A Chapter 1 Installing VTL Value hardware 5