Sun Microsystems EC000066 manual Mounting the appliance in the rack

INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK

6.Once both slide rails are loosely fastened at the rear, insert the slide-rail spacing tool into the outer rail brackets (D below).

D

E

F

7.Hold the spacing tool in place (E above) as you tighten all four rear screws with a #2 Phillips screwdriver (F).

The spacing tool should be a snug fit and might require pressure to ensure that it is fully engaged with the left and right slide rails.

8.Pull the slide-rail spacing tool straight out from the slide rails, taking care not to deform its alignment tabs.

Next task: “Mounting the appliance in the rack” on page 13.

Mounting the appliance in the rack

Once the inner rails are attached to the appliance chassis and the outer/middle rail assemblies are attached to the rack, you are ready to install the appliance in the rack. Proceed as follows.

316196101 • A Chapter 1 Installing VTL Value hardware 13