Sun Microsystems EC000066 manual Sun Rack 1000 hardware uses metric screws

INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK

5.If the rack has threaded mounting holes in the rack posts, insert the correct, metric or standard mounting screws through the slide-rail brackets and into the threaded holes.

The Sun™ Rack 1000 hardware uses metric screws.

6.If your rack does not have threaded mounting holes, insert the mounting screws through both the slide-rail brackets and rack posts, and then secure them with caged nuts.

7.Hand-tighten the screws in the front bracket holes (K below). You will use a slide-rail spacing tool later to make final adjustments.

K

8.Repeat this procedure with the remaining, unsecured middle/outer rail. Next task: “Adjusting and securing middle/outer slide rails” on page 11.

10 VTL Value Hardware Installation Guide • Aug 2007 A • 316196101