REMOVING THE VTL APPLIANCE FROM A RACK
3.Push the green plastic tabs on the middle slide rails to release the second stop and pull the server out about 36 inches from the rack.
4.If you do not have a mechanical lift, open the hard disk drive access cover and remove the disk drives in slots 2 to 46 and follow the important instructions in “If a mechanical lift is not available, make sure that at least four trained people are available to remove the server and/or reduce the weight of the server by removing components:” on page 51.
5.Slide the server completely out of the slide rails and place on a clean, stable surface.
Note – If you are removing the server in a data center with narrow aisles (under
44 inches or approximately 1.12 meters wide), you can order a narrow aisle removal kit from Sun Service.
52 VTL Value Hardware Installation Guide • Aug 2007 | A • 316196101 |
