Sun Microsystems EC000066 manual Adjusting and securing middle/outer slide rails

INSTALLING THE VTL VALUE APPLIANCE IN AN EQUIPMENT RACK

▼Adjusting and securing middle/outer slide rails

1.Once both slide rails are loosely fastened at the front, insert the slide-rail spacing tool/rack installation aid (A below) into the outer rail brackets at the front of the rack (B).

A

B

C

2.Hold the slide-rail spacing tool in place as you tighten all four front screws with a #2 Phillips screwdriver (C above).

The spacing tool should be a snug fit and might require pressure to ensure that it is fully engaged with the left and right slide rails.

3.Pull the slide-rail spacing tool straight out from the slide rails, taking care not to deform its alignment tabs.

316196101 • A Chapter 1 Installing VTL Value hardware 11