8. While a second person holds the console as-

8

Console

sembly near the Pulse Bar (66), connect the

 

Assembly

Console Ground Wire (107) on the Pulse Bar to

 

 

 

the ground wire from the console assembly.

 

 

Connect the wire from the console assembly to

Ground

75

the Upright Wire (75). Make sure to connect

the connectors properly (see the inset draw-

Wire

 

 

 

ing). The connectors should slide together

 

 

easily and snap into place. If the connectors

 

 

do not slide together easily and snap into place,

 

107

turn one connector and then try again. IF THE

 

CONNECTORS ARE NOT CONNECTED

 

Wire

PROPERLY, THE CONSOLE MAY BE DAM-

66

75

AGED WHEN THE POWER IS TURNED ON.

Lay the wires inside the bottom of the Pulse Bar

 

76

(66).

 

 

 

9. Set the console assembly on the Left and Right

9

 

Uprights (70, 76). Be careful not to pinch any

Console Assembly

 

wires.

 

 

Attach the console assembly to the Pulse Bar

 

 

(66) with six 3/4" Screws (23). Start all six

 

 

Screws before firmly tightening them.

 

 

 

 

 

66

 

 

 

 

23

23

23

 

 

 

70

 

 

76

10. Identify the Left Handrail Cover (68), which has

10

 

 

 

 

a LEFT sticker on it. Slide the Left Handrail

Console

 

 

 

 

 

 

 

Cover onto the left Handrail (62) and hold it

 

Assembly

 

 

 

against the console assembly. Tighten two

 

 

 

 

 

Cover Screws (52) into the Left Handrail Cover

 

68

 

 

 

and the Left Upright (70); be careful not to

 

 

 

 

 

62

 

 

 

overtighten the Cover Screws.

 

 

 

 

Attach the Right Handrail Cover (74) in the

 

 

 

 

 

same way.

 

 

 

 

 

 

 

52

70

 

 

 

 

 

 

74

 

 

 

 

62

 

 

 

 

 

52

76

 

 

 

 

 

 

9

 

 

 

 

Page 9
Image 9
ProForm PFTL49507.0 user manual Connectors are not Connected