2.Orient the Left Upright (31) as shown, and attach it to the Base (48) with two 3/8" x 2 1/4" Bolts (40) and two 3/8" Star Washers (39); do not tighten the Bolts yet.
3.Attach a Wheel (45) to each side of the Base (48) with a 3/8" x 2 1/4" Bolt (40), two Wheel Spacers (44), and a 3/8" Nut (47) as shown. Do not overtighten the Bolts; the Wheels should turn freely.
4.Raise the Uprights (31, 36) so that the Base (48) is flat on the floor and positioned as shown.
See the far right drawing. Wrap the wire tie in the Right Upright (36) around the end of the Upright Wire (28). Then, pull the other end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright.
Make sure that the end of the Upright Wire (28) does not fall into the Right Upright (36).
2 |
|
|
|
|
|
| Latch |
|
|
|
| Holes |
|
|
|
| 48 |
|
|
|
| 31 |
|
|
|
|
|
| 39 |
|
|
| 39 | 40 |
|
|
|
| |
3 |
| 45 | 44 | |
|
| 44 |
| 40 |
|
|
|
| |
|
| 47 |
|
|
| 45 | 44 |
|
|
| 44 | 47 |
|
|
|
|
|
| |
| 40 | 48 |
|
|
|
|
|
| |
4 | 28 |
|
|
|
|
|
|
| |
Wire Tie
31 | 36 | 28 |
Large
Hole
Wire
Tie
48
7
