12.Attach the ground wire on the Upright Wire (28) to the indicated hole in the Base (48) with a 1/2" Ground Screw (11).
Press the Upright Grommet (90) into the Right Upright (36).
Raise the Uprights (31, 36).
13.Attach the Latch Housing (30) to the Left Upright (31) with two 3/4" Screws (2). Make sure that the large hole in the Latch Housing is on the side shown. Do not overtighten the Screws.
12
90
36
28
48 
Hole 
Ground
Wire
11
13
30
31
Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (30), and tighten the knob onto the pin.
Knob 
2 
Large Hole
Pin
Spring
Collar
14.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 22). To protect the floor or carpet, place a mat under the treadmill.
11
