ProForm PFTL54806.0 user manual Do not tighten the Nuts yet

2. Have a second person hold the Base (52) in the	2
position shown.
Identify the Left Upright (53) (the Right Upright [54]			9
has a large hole near the lower end).		14
	2			16
Hold the Left Upright (53) so that the two small
	54
holes are on top as shown. Insert two Upright
Bolts (2) with two Upright Washers (14) into				9		9
the base of the Left Upright. Attach the Left		Large		52	14	16
Upright to the Base (52) with the Upright Bolts,
		Hole
two Upright Star Washers (9), and two Nuts (16).
	Small Holes		2
Do not tighten the Nuts yet.
						9
Attach the Right Upright (54) to the Base (52) in
the same way.			53
3. Slide the two Wheel Housings (45) onto the Base	3
(52). Attach each Wheel Housing with two Wheel			32
		45
Housing Bolts (13), two Wheel Housing Washers				43
(32), and two Wheel Housing Nuts (43).
	13		32
						32
				45		43
				13		32
				52
4. Position the Base (52) as close to the front of the	4			4a	54
treadmill as possible, as shown.
					Strap
			39
See drawing 4a. Locate the strap in the lower
end of the Right Upright (54). Wrap the strap	Strap
around the Wire Harness (39) and secure the
strap using the included plastic tie. Then, insert						39
the connector into the square hole in the Right			54
Upright. Pull the opposite end of the strap until	52			Tie
the end of the Wire Harness is pulled through the
Right Upright.
See drawing 4b. Press the indicated Grommet				4b
(49) into the Right Upright (54).						54
						49
				39		52
	7