ProForm PFTL79008.0 guide



20.	Never leave the treadmill unattended while it		24.	Inspect and properly tighten all parts of the
	is running. Always remove the key, unplug			treadmill regularly.
	cuit breaker to the off position when the		25. DANGER: Always unplug the power
	the power cord, and switch the reset/off cir-			cord immediately after use, before cleaning the
	treadmill is not in use. (See the drawing on
	page 5 for the location of the circuit breaker.)			treadmill, and before performing the mainte-
21.	Do not attempt to raise, lower, or move the			nance and adjustment procedures described in
				this manual. Never remove the motor hood un-
	treadmill until it is properly assembled. (See			less instructed to do so by an authorized ser-
	ASSEMBLY on page 6, and HOW TO FOLD			vice representative. Servicing other than the
	AND MOVE THE TREADMILL on page 21.)			procedures in this manual should be performed
	You must be able to safely lift 45 lbs. (20 kg)			by an authorized service representative only.
22.	to raise, lower, or move the treadmill.		26. This treadmill is intended for in-home use
	When folding or moving the treadmill, make			only. Do not use this treadmill in a commer-
	sure that the storage latch is holding the			cial, rental, or institutional setting.
23.	frame securely in the storage position.
	Never insert any object into any opening on
	the treadmill.	SAVE THESE INSTRUCTIONS

4

Image 4

ProForm PFTL79008.0 manual

Contents

QUESTIONS? Model No. PFTL79008.0 Serial NoMon.-Fri a.m.-6 p.m. MT Sat a.m.-4 p.m. MT On the WEB Table of Contents Local electronics store Important PrecautionsPulse sensors are not medical devices Page Before YOU Begin Assembly Do not fully fold the Frame yet Make sure that the power cord is unpluggedTighten the Nut the Wheel must turn freely Right Upright do not fully tighten the Bolts Yet With a second Bolt Spacer 95, 3/8 x 4 Bolt 3/8 Star WasherNot fully fold the Frame yet Bolts yet Not Connected PROPERLY, the CON Sole MAY be Damaged When Wires Uprights 77, 92. Be careful not to pinch anyScrews before firmly tightening any of them Same way Does not come apart. Note See the lower Attach the other Crosswalk Arm 82 Raise the Frame 48 to the position shown HOW to PUT on the Chest Pulse Sensor HOW to USE the Chest Pulse SensorChest Pulse Sensor Care and Maintenance HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the Console HOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode. When you Insert the key into the console Measure your heart rate if desired Follow your progress with the displays. WhenTurn on the fan if desired HOW to USE a Preset Workout Select a preset workout Information Mode HOW to USE the Crosswalk Arms HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingCompatible with GFCI-equipped outlets Problem The walking belt slows when walked on Top Problem The crosswalk arms squeak during use Turn if the walking belt has shifted to the right Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise Frequency Part LIST-Model No. PFTL79008.0 Key No. Qty Description Qty Exploded Drawing A-Model No. PFTL79008.0 R0109A Exploded Drawing B-Model No. PFTL79008.0 R0109A 10195 102 103 111 Exploded Drawing D-Model No. PFTL79008.0 R0109A Limited Warranty Ordering Replacement PartsIcon Health & Fitness, Inc., 1500 S W., Logan, UT