PROBLEM: The walking belt is |
|
|
| |
SOLUTION: a. If the walking belt is | a |
|
| |
key and UNPLUG THE POWER CORD. If the |
|
| ||
walking belt has shifted to the left, use the hex |
|
|
| |
key to turn the left idler roller bolt clockwise 1/2 of a |
|
|
| |
turn; if the walking belt has shifted to the right, |
|
|
| |
turn the idler roller bolt counterclockwise 1/2 of a |
|
|
| |
turn. Be careful not to overtighten the walking belt. |
|
|
| |
Then, plug in the power cord, insert the key, and |
|
|
| |
run the treadmill for a few minutes. Repeat until the |
|
|
| |
walking belt is centered. |
|
|
|
|
b. If the walking belt slips when walked on, first re- | b |
|
| |
move the key and UNPLUG THE POWER CORD. |
|
| ||
Using the hex key, turn both idler roller bolts clock- |
|
|
| |
wise, 1/4 of a turn. When the walking belt is cor- |
|
|
| |
rectly tightened, you should be able to lift each |
|
|
| |
edge of the walking belt 2 to 3 in. (5 to 7 cm) off |
|
|
| |
the walking platform. Be careful to keep the walk- |
|
|
| |
ing belt centered. Then, plug in the power cord, in- |
|
|
| |
sert the key, and carefully walk on the treadmill for |
|
|
| |
a few minutes. Repeat until the walking belt is |
|
|
| |
properly tightened. |
|
|
|
|
PROBLEM: The crosswalk arms squeak during use |
|
|
|
|
SOLUTION: a. (Note: Correcting this problem re- | a |
|
|
|
quires a small amount of white ma- |
|
|
| |
rine grease, available at hardware |
|
|
|
|
stores.) Remove the Resistance |
| 77 |
|
|
Knob (88) from the resistance as- |
|
|
| |
sembly. Remove the resistance as- | 88 |
|
| 92 |
sembly from the Left Upright (77) or | 85 | Resistance | ||
the Right Upright (92). |
|
| ||
|
| Assembly |
| |
Apply a small amount of grease |
|
|
|
|
around the Resistance Cone (85). |
|
|
|
|
Insert the resistance assembly into |
|
|
|
|
the Left Upright (77) or the Right |
|
|
|
|
Upright (92). Then, tighten the |
|
|
|
|
Resistance Knob (88) onto the re- |
|
|
|
|
sistance assembly. |
|
|
|
|
24
