If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re- ceiver and the short jumper wire included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Console Back Screws (87) from the Console Back (88). Remove the Console Back from the Console Base (81).
2.Connect the short jumper wire (A) to the wire on the re- ceiver (B). Connect the other end of the short jumper wire to the PULSE jack on the back of the Console (see draw- ing 2b). Note: If there is a wire already plugged into the PULSE jack, unplug it.
Next, peel the paper off the pad on the back of the receiver
(B). Turn the receiver so the small cylinder is on the side shown, and press the receiver into the bottom of the Console Base (81) in the indicated location. Use the in- cluded wire tie to tie wires if needed. Note: The other wires included with the receiver may be discarded.
Make sure that no wires are pinched. See step 1. Reattach the Console Back (88) with the Console Back Screws (87).
1 |
| 88 | 81 |
|
|
| |
|
| 87 |
|
2a | 81 | 2b |
|
|
| PULSE |
|
|
| Jack |
|
A
Cylinder
B 
8
