3.Insert a Handrail Extension (66) into the post on the right Upright (69) as shown; make sure that the indicated holes are on top. Tap the Handrail Extension with a rub- ber mallet to fully insert it. Attach the Handrail Extension with two 1/2” Screws (67) as shown.
Identify the Right Foam Grip (75), which has a large cutout in the left side for the Pulse Bar (76). Slide the Right Foam Grip as far as possible onto the post on the right Upright (69). (Note: It may be helpful to apply soapy water to the Handrail Extension [66].) Make sure that the tab on the
Foam Grip is inserted into the Console Base (81).
4.Make sure that the front edge of the Right Foam Grip (75) is under the Console Base (81) as shown. Tighten a 3/4” Screw (100) into the side of the Right Foam Grip. Note: It may be necessary to pull the Foam Grip outward slightly (see arrow A) to align the Screw with the hole in the post.
Attach the other Handrail Extension (not shown) and the Left Foam Grip (not shown) as described in step 3 and this step.
5.Attach the Latch Assembly (11) to the Left Upright (69) with the two Latch Screws (74). Start both Latch Screws before tightening them. Note: It may be neces- sary to remove the Latch Screws from the Left Upright before attaching the Latch Assembly.
3 |
|
|
|
76 |
|
| 81 |
Tab | 67 |
|
|
Cutout | Holes |
|
|
|
|
| |
75 |
| 69 |
|
|
|
| |
| 66 | Post |
|
|
|
| |
4 |
|
|
|
|
| A | 81 |
|
|
| |
|
| 100 |
|
|
| 75 |
|
5 |
|
|
|
| 11 |
|
|
74 |
| 69 |
|
6.Clean the Reading Rack (80) with a soft cloth and rubbing alcohol.
Remove the paper backing from the strips of tape on the Console Base (81). Position the Reading Rack (80) so the straight edge is pressed against the plastic around the Console (82). Press down on the Reading Rack while pressing up on the bottom of the Console Base. Wait for 24 hours before setting a book on the Reading Rack.
6 | 80 |
| |
| Edge |
| Tape |
| Tape |
82 | 81 |
|
7.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 24). To protect the floor or carpet from damage, place a mat under the treadmill.
7
