ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires your own phillips screw-

driver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

For help identifying the assembly hardware, see the PART IDENTIFICATION CHART below.

3/4” Tek

1/2” Screw (67)–4

Latch Screw (74)–2

Screw (100)–6

 

 

1. With the help of a second person, carefully raise the

1

treadmill to the upright position as shown.

 

 

69

 

 

Insert one of the Extension Legs (102) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (99) is on the bottom. If necessary, tip the Uprights (69) forward as you insert the Extension Leg.

Insert the other Extension Leg (not shown) in the same way.

 

 

 

102

 

 

 

99

2.

With the help of a second person, carefully lower the

2

 

 

treadmill frame and then tip the Uprights (69) down as

 

 

 

 

 

shown. Make sure that the Extension Legs (102) remain

 

 

 

in the Uprights.

 

 

 

Attach each Extension Leg (102) with two 3/4” Screws

 

99

 

 

 

 

(100) as shown.

 

Frame

 

With the help of a second person, carefully tip the

 

69

 

Uprights (69) back to the vertical position.

 

 

 

69

100

 

Note: One replacement Base Pad (99) may be included.

102

 

 

 

Use the extra Base Pad if one becomes worn or needs to

99

100

 

be replaced.

 

 

102

 

 

 

6

Page 6
Image 6
ProForm PFTL79103 user manual Assembly, Shown. Make sure that the Extension Legs 102 remain Uprights