5.Press the Latch Sleeve (89) into the left Upright (99). Note: It may be helpful to use a rubber mallet to fully in- sert the Latch Sleeve.
Remove the latch knob from the latch pin. Make sure that the latch pin collar and the spring are on the latch pin. (Note: If there are two latch pin collars, place one on each side of the spring.) Insert the latch pin into the left Upright (99), and tighten the latch knob back onto the latch pin.
6.Remove the backing from the indicated tape on the con- sole assembly. Press the Book Holder (62) firmly onto the tape. Note: The Book Holder may be preassembled.
5 |
|
| Collar |
Knob |
|
89 | Pin |
| |
Spring |
|
99 |
|
6 |
|
62 |
|
Console |
|
Assembly |
|
Tape |
|
7.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the walking belt (see page 28). To protect the floor or carpet, place a mat under the treadmill. If there is a sheet of clear plastic on a decal, remove the plastic.
If you purchase the optional chest pulse sensor (see page 24), follow the steps below to install the receiver included with the chest pulse sensor.
1.MAKE SURE THAT THE POWER CORD IS UN- PLUGGED. Remove the indicated Screw (2) and the Access Door (95).
2.Remove the paper from the adhesive pad on the back of the receiver (A). Orient the receiver so the small cylin- der is near the lower edge of the receiver and is fac- ing the Console Back (85) as shown. Firmly press the receiver onto the indicated corner of the Access Door
(95).Connect the wire on the receiver to the Pulse Wire
(49)extending from the Console Back.
3.Make sure that no wires are pinched. Reattach the Access Door (95) with the Screw (2). Discard the other wires included with the receiver.
| 85 |
49 |
|
A |
|
Cylinder | 95 |
| 2 |
8
