7. Set the console assembly face down on a soft | 7 |
|
|
surface to avoid scratching the console assem- |
|
| |
| Console |
| |
bly. Hold the Right Handrail (95) near the con- |
|
| |
| Wire |
| |
sole assembly. Next, insert the console wire into |
|
| |
|
|
| |
the large hole in the Right Handrail and out of |
|
|
|
the top as shown. If necessary, use needlenose |
|
|
|
pliers to help pull the console wire out. | 95 | 1 |
|
Attach the Right Handrail (95) and the Left |
|
| 1 |
|
|
| |
Handrail (not shown) with four #8 x 3/4" Screws |
|
|
|
(1) (only one side is shown). Make sure that no |
|
|
|
wires are pinched. Start all four Screws be- | Console |
|
|
fore tightening any of them; do not over- |
|
| |
Assembly |
|
| |
tighten the Screws. |
|
| |
|
|
| |
8. Tighten a 1/4" x 1 1/4" Bolt (5) with a 1/4" Star | 8 | Wire |
|
Washer (33) into the bracket and Handrail |
| ||
|
| ||
Crossbar (94) on each side of the console as- |
| Tie |
|
sembly (only one side is shown). |
| 5 |
|
|
|
| |
Remove the wire tie from the console wire. |
| 33 |
|
|
|
| |
| Console |
|
|
| Assembly |
|
|
|
| 94 |
|
9. Remove the long tie from the Upright Wire (38). | 9 |
|
|
|
|
| |
Have a second person hold the console assem- |
|
|
|
bly near the Right Upright (78) and Left Upright |
|
|
|
(not shown). Connect the Upright Wire (38) to | Console |
|
|
the console wire. See the inset drawing. The |
|
| |
connectors should slide together easily and | Assembly |
|
|
snap into place. If they do not, turn one connec- |
|
|
|
tor and try again. IF THE CONNECTORS ARE |
|
|
|
NOT CONNECTED PROPERLY, THE CON- |
|
|
|
SOLE MAY BE DAMAGED WHEN THE | Console |
|
|
POWER IS TURNED ON. |
|
| |
Wire |
|
| |
Set the console assembly on the Right Upright |
| 38 | Console |
(78) and Left Upright (not shown). Be careful |
|
| |
|
| Wire | |
not to pinch the wires. |
| Long | |
78 |
| ||
| Tie |
| |
|
|
| 38 |
| 9 |
|
|
