8.Cover the Upright Wire (42) with the Right Grip Plate
(36). Be careful not to pinch the Upright Wire. Tighten two 1/2” Screws (48) and a 3/4” Screw (2) into the Right Grip Plate and the Console Base (47).
9.Attach the Latch Housing (29) to the left Upright (69) with two 3/4” Screws (2). Make sure that the large hole in
the Latch Housing is on the side shown.
Remove the knob from the pin. Make sure that the col- lar and the spring are on the pin as shown. Then, in- sert the pin into the Latch Housing (29), and tighten the knob back onto the pin.
8 |
|
|
| 47 |
|
|
| 42 |
|
|
|
| 36 |
|
| 48 |
| 2 |
|
|
|
|
| |
9 |
|
|
|
|
|
|
| 29 | 69 |
Knob |
|
| Large | |
|
| 2 |
| Hole |
|
| Spring | Collar | |
|
|
| Pin | |
|
|
|
|
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place; the large allen wrench is used to adjust the walking belt (see page 26). To protect the floor or carpet, place a mat under the treadmill.
9
