Notices
iii
Radio Frequency Interference Statement This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection agains t harmful interference in a residentia l
installation. This equipment generates, uses and can radiate radio frequency
energy, and, if not installed and used in accordance with the instruction may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, whic h
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult Promise Technology, Inc. or an experienced radio/TV technician for
help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following conditions: (1) This device may not ca use harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation. Note Only digital device equipment CERTIFIED
CLASS B should be attached to this equipment and that must have shielded
cables.
Power Supply Notice Promise Technology recommends that you compare the capacity of your Power
Supply against the wattage required by your PC plus the disk drives you plan to
install in the SuperSwap 4600. Upgrade your Power Supply if necessary.
Do not use a Y-connector to share power between the SuperSwap 4600 and
another device.
Do not use a Y-connector to share power among the three power connectors on
the SuperSwap 4600.
Attach each SuperSwap 4600 power connector directly to the Power Supply.