![](/images/new-backgrounds/1120994/12099451x1.webp)
VTrak M310p, M210p Quick Start Guide
Internet Connection using WebPAM
The above instructions cover connections between VTrak and your company network. It is also possible to connect to a VTrak from the Internet.
Your MIS Administrator can tell you how to access your network from outside the firewall. Once you are logged onto the network, you can access the VTrak using its IP address.
While only a
Frequently Asked Questions
What kind of disk drives can I use with VTrak?
VTrak supports 1.5 and 3.0 Gb/s Serial ATA disk drives.
Can I take the disk drives from my UltraTrak, put them into the VTrak and keep my disk array or logical drive intact?
Yes. UltraTraks, except for JB4000, and early VTrak subsystems used a proprietary method of disk metadata, stored in the reserve sector of each physical drive. VTrak M310p/M210p use the
Note that if you move the disk drives from the VTrak M310p/M210p to the older subsystems, they will not recognize your disk array or logical drive.
Can I use my existing SCSI card with VTrak M310p/M210p?
Yes. For best performance results, use an Ultra320 SCSI card.
How can I tell when the VTrak has fully booted?
During the VTrak
Why does VTrak come with a Command Line Utility?
First, to assign your VTrak an IP address in order for the WebPAM management software to connect to it. Second, in the event of a network failure, you can still access the VTrak. Third, some users prefer the Command Line Utility.
26